REFILLING INSTRUCTIONS OF PITNEY BOWES 793-5:

1.Peel off the sticker on the top front of the cartridge (original Pitney Bowes
cartridges have a sticker that covers the entire top side of the cartridge, whereas NuPost Compatible cartridges have a smaller sticker)

2.Underneath the sticker, you will notice at least 1 hole. Locate the hole that is covered by a silver foil seal tab, this silver seal covers the filling hole. (If you do not see this hole in your cartridge, please use the illustration to your right to create a hole to refill the cartridge).

3.Attach the needle to the syringe and draw up 8ml of compatible ink.

4.Either insert the needle through the silver seal, or remove the seal first using a small knife or blade and then insert the needle through the filling hole. (do NOT insert the needle through any hole that has a rubber protrusion, as indicated by the lower hole in this Nupost compatible cartridge). The filling hole should
provide no initial resistance to your needle other than the seal that lies above it. Once you insert the needle into the cartridge, you will begin to feel some resistance due to the sponge inside the cartridge, it is OK to penetrate this sponge. Push the needle gently through to the bottom of the sponge, and inject about 8cc (8ml) of ink or until the cartridge is full. You will know the cartridge is full because the sponge will no longer be able to hold any more ink.

5.Attach the needle to the syringe and draw up 8ml of compatible ink.