52110001, 52110002, 52110003, 52110004

1. The filling hole is located under the label as shown. Just peel back the label leaving it still connected to the cartridge, do not remove completely.

2. Use the provided eyelet screw to drill a filling hole on the top of the cartridge(s)
opposite side of the sponge.

3. Connect the needle to the syringe and fill with ink.

4. Insert the needle into the filling hole and inject about 5ml of ink.

5. Use the provided plug to seal the hole. Note: If the cartridge has been empty/ dry, the sponge will no longer accept any ink which will cause the cartridge to leak. Pull the label back into place and use a piece of tape to hold it in place.

6. Rinse the syringe with water and dry between each color refill or store for future use.

7. Reinsert cartridge back into the printer and run 1 - 3 cleaning cycles as per printer instructions.

Note: Immediately refill any empty cartridges