Refilling the HP 02 Cartridge

1.Use the enclosed eyelet screw to create the filling hole at the top of the cartridge. Picture A, on the right, illustrates where the refill hole should be created.

2.Fill the syringe with ink. Insert the needle into the filling hole and push down into the cartridge. Inject up to 20ml of ink or until the cartridge is full. Do not exceed 30ml on these cartridges. It is always better to under fill than over fill any cartridge. You can always add more ink later.

3.Once your cartridge has been filled, remove the needle from the cartridge and plug the top of the cartridge with the plugs provided in your refill kit. Please make sure to seal the plug tight so that no extra air goes in our out of the cartridge as it prints. You will also avoid any
spills as well.

Note:OEM (original) black cartridges usually come with only 12ml of ink, so if you’re refilling an original it may only hold 12ml. Uni-Kit compatible cartridges hold more.

Refilling the Color Cartridges:

1.Use the enclosed eyelet screw to create the filling hole at the top of the cartridge. Picture A, on the right, illustrates where the refill hole should be created.

2.Fill the syringe with ink. Insert the needle into the filling hole and push down into the cartridge. Inject up to 9ml of ink or until the cartridge is full. Do not exceed 9ml on these cartridges. It is always better to under fill than over fill any cartridge. You can always add more ink later.

3.Once your cartridge has been filled, remove the needle from the cartridge and plug the top
of the cartridge with the plugs provided in your refill kit. Please make sure to seal the plug
tight so that no extra air goes in our out of the cartridge as it prints. You will also avoid any
as well.

Note:On OEM HP cartridges, there is a small dimple located near the HP emblem as illustrated on picture B. If this dimple is on your OEM HP cartridges, please create the refilling hole through it Picture B shows a refilling hole which was created through the dimple of a yellow HP OEM cartridge.

Reinstalling the Cartridges

Reinstalling:

1.Open the lid to your printer.

2.Place your refilled cartridge into the cradle that corresponds with the color of the 2. tank.

3.Close the lid to your printer.

4. A prompt will then display on your printer screen saying “Original HP Ink Dep leted”.

5.On your printer will be a circle of buttons with “OK” in the middle and arrowkeys. Press the right arrow key.

6.A prompt will then display on your printer screen saying “Attention”.

7.Press the “OK” button on your printer.

NOTE: The ink levels will not show on the screen. However, once the volume of ink has been depleted from the replaced tank, the printer will not allow you to print any further until the tank has been refilled again.