LC41C, LC41M, LC41Y, LC41BK

1. Lay the cartridge down with the label facing up. Using the eyelet screw provided, begin
twisting the screw into the top of the cartridge. Continue twisting until it pierces the
plastic cover. Once the plastic to is pierced, making the rest of the hole will go very
quickly.

2. Connect the needle to the syringe and fill ink.

3. Insert the syringe into the hole and inject about 20 ml. of ink

4. Seal the filling hole with one of the included tape dots.

5. Rinse the syringe with water and dry between each color refill or store for future use.

LC25Bk, LC25C, LC25M, LC25Y

1. Use the eyelet screw to remove the white plug located next to the exit hole. The plug
does not need to be removed completely since the white plug and the exit hole plug are
connected.

2. Connect the needle to the syringe and fill with ink.

3. Insert the syringe through the filling hole which is found where the white plug was
removed.

4. Inject up to 8 ml. of ink (this cartridge is transparent so you will see the ink level) then
reseal the cartridge with the plug that was removed from step 1. Make sure that the
small plastic tip of the plug sits back into the filling hole.

5. Rinse the syringe with water and dry for future use, or use with a different color ink.

6. Reinsert the cartridge(s) and run a priming cycle as per printer instructions.
Note: Immediately refill any empty cartridge