LC04C, LC04M, LC04Y, LC04BK

1. Put a piece of tape over the bottom hole of the cartridge.

2. Use a flathead screwdriver to remove the cover by prying up the clip holding the cover
on the cartridge.

3. Using a knife remove the large silver seal.

4. Underneath the large silver seal there are two holes (filling hole and vent hole), use the
eyelet screw to widen the hole closest to the center of the cartridge (not the hole closest
to the edge of the cartridge)

5. Connect the needle to the syringe and fill ink.

6. Insert the syringe into the hole that was located under the large silver seal. Note: You
may feel a slight pressure because the cartridge contains a sponge.

7. Inject about 7 ml. of ink and seal the filling hole and vent hole with a piece of tape.

8. Snap the plastic cover back onto the cartridge the same direction it came off.

9. Rinse the syringe with water and dry between each color refill or store for future use.

10. Remove the tape covering the bottom hole and reinsert the cartridge(s) and run a
priming cycle as per printer instructions.